GE JGP989 manual Glass surface-potentialfor permanent damage, Instructions Safety, Tips, Consumer

Instructions

Cleaning the glass cooktop.

Instructions Safety

The CERAMA BRYTE® Ceramic Cooktop Scraper and all recommended supplies are available through our Parts Center. See instructions under “To Order Parts” section below.

NOTE: Do not use a dull or nicked blade.

Heavy, Burned-On Residue

Allow the cooktop to cool.

Remove the burner grates, vent grille and vent grille gasket.

Use a single-edge razor blade scraper at approximately a 45° angle against the glass surface and scrape the soil. It will be necessary to apply pressure to the razor scraper in order to remove the residue.

After scraping with the razor scraper, spread a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner to the entire burned residue area. Use the CERAMA BRYTE® Cleaning Pad to remove any remaining residue.

For additional protection, after all residue has been removed, polish the entire surface with CERAMA BRYTE® Ceramic Cooktop Cleaner and a paper towel.

Care and Cleaning Operating

Metal Marks and Scratches

Be careful not to slide pots and pans across your cooktop. It will leave metal markings on the cooktop surface.

These marks are removable using the CERAMA BRYTE® Ceramic Cooktop Cleaner with the CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops.

WARNING: Carefully check the bottom of pans for roughness that would scratch the cooktop.

Glass surface—potential for permanent damage.

Tips

Our testing shows that if you are cooking high sugar

Damage from Sugary Spills and Melted Plastic

Support Troubleshooting

mixtures such as jelly or fudge and have a spillover, it can cause permanent damage to the glass surface unless the spillover is immediately removed.

Turn off all surface burners and, with an oven mitt, remove hot pans and grates.

Wearing an oven mitt:

a.Use a single-edge razor blade scraper (CERAMA BRYTE® Ceramic Cooktop Scraper) to move the spill to a cool area on the cooktop.

b.Remove the spill with paper towels.

Any remaining spillover should be left until the surface of the cooktop has cooled.

Don’t use the surface units again until all of the residue has been completely removed.

NOTE: If pitting or indentation in the glass surface has already occurred, the cooktop glass will have to be replaced. In this case, service will be necessary.

Consumer

To Order Parts

To order CERAMA BRYTE® Ceramic Cooktop Cleaner and the cooktop scraper, please call our toll-free number:

	National Parts Center	800.626.2002
14	CERAMA BRYTE®
	Ceramic Cooktop Cleaner . . . .# WX10X300

CERAMA BRYTE®

Ceramic Cooktop Scraper . .# WX10X0302

Kit . . . . . . . . . . . . . . . . . . . . . .# WB64X5027 (Kit includes cream and razor scraper)

CERAMA BRYTE® Cleaning Pads for Ceramic Cooktops . . . . . . . . . . .#WX10X350