❑IF WGE WfiMDING ~LOW
LIGHT MD WJUST SURWE BURNER PILO~
1.Purge dl air from supply system by turning one top burner valve fu~y ON for 15 seconds.
2.Turn valve OFF and fight pilot burners. Adjust pilot flames using adjusting screw at the manifold pipe, so that each flame is approtiately l/4inch in height.
3.To fight any top burner, push and turn burner knob to the fite position.
4.men burner has ignited, rotate knob to desired flame setting.
Surface Burner Pilot | ,/ |
|
(If equipped) | ~ Pilot Adjustment Screw | |
| Lefi | Pilot |
1/4. Approx. | Mantiold |
|
Pl~ | Right Pilot | |
k Pilot Flame <
d
❑IF WGE W ELECTRIC lGHITION–
There are separate ignition devices for the left and right had surface burners. Both of these igniters are ON when any knob is turned to the L~ setdng. The igniters wi~ “spark” as long as any of the top burner knobs are at the ~ setting.
h the event of an electrical power failure, the top burners m sti~ be used. To fight a burner, hold a hghted kitchen match adjacent to the top burner to be used and turn valve knob to HTE. USE
❑OVEN PILOT ~JUSTMEHT
On pilot models remove thermostat knob. Check position of pflot gas selector to make sure selector is turned to the correct position for the type of gas that is to be used. To change to L~ insert sd blade screwdriver in slot and turn fu~y counterclockwise so that indicator points to LPG. To change to NAT, turn fully clockwise so that indimtor poinb to NAT
●H desked, the @ to the oven pflot - be turned off by tur~ the selector so the pointer is at the 0~ position, mid- between the WG and NAT
●On electric i~tion models the es to the oven burner - be turned off. A manti
31
