GE JGAS02PN, JMS02PN manual that appfies, regulator, remove, converter cap by, twisting. Turn cap

❑ONVE~ BURHERORIFICWMD ~ESURE REGUWTOR OF HECEM~

LP GAS S~lNG

1.CO~R~G BURNER O~C~ TO W GAS

Tighten the orifice hoods for the surface burners and oven burner approtiately two complete turns to the closed position and adjust top pilots, if equipped. The gas pressure regulator must be converted to the LP gas setting so hat it ~ provide a pressure of 10 inches water column to the range manifold.

NAT. GAS S~lNG

2.COMR~G B-R OMC~

TO NA~ GAS (ONLY IF RANGE W BEEN OPEMTED P~OUSLY ON LP G-)

Unscrew the orifice hoods for W burners (top and oven) approtiately two complete turns, until the flame on the burner does not increase in length. Adjust the top pilots (if equipped). The gas pressure regulator must be set to the natural gas setting so that it til provide a pressure of 4 inches of water column in tie range manifold.

3. REG~TOR CO~RSION

Al ranges are equipped with a gas pressure regulator for controbg and maintig a uniform gas pressure in the gas manifold of the range. The burner ofices are sked for the gas pressure defivered by the regulator suppfied. me pressure regulator must not be removed. To convert the regulator from one gas to another, refer to the fo~owing Nustration

that appfies:

1. For a Harper-Wyman					.
regulator, remove			LPG
				~<e$e’,9 NAT
converter cap by
inserting a coin into			e“>G9
slot in t;p and			v’
twisting. Turn cap
over and reinsti.
			Q		Ha~er-Wyman
			@Regulator
2. On the Mtitrol				/	,/’
re~tor, unscrew
			Q&
cap, dislodge the			./	d L LPG
plastic	converter		/
plunger from the tip,				Q
turn converter			8
plunger	over,	r~ksert ‘NAT ~			M=itrol
the converter		plunger	@
					Regulator

into cap and replace ap.

N~: What you read on the converter cap or plunger is the type of gas for which the regulator

is set. E yours reads NAT, the regulator is set for natud gas. Hyours reads L~ the regulator is set for ~.

●FOR PROPER OPERA~ON, THE MMUM INLET PRESSURE TO THE REGUMTOR MUST BE NO MORE THAN 14 INCHES OF WATER COLUMN PRESSURE. For checbg the re~lator, the inlet pressure must be at least l-inch of water column (3.4 WA) greater than the regulator output setting. E the regulator is set for 4 inches of water column pressure, the inlet pressure must beat least 5 inches. E the regulator is set for 10 inches, the Met pressure must be at least 11 inches.

●The gas supply he to the range should be 1/2

inch or 3/4 inch pipe.

3.For standing pflot models, m~e the necessary oven pilot adjustment (see directions in ~P 7). Nso burner ti shutter adjustments may be necessary on ~ models to complete conversion (see ~P 9).

29