❑~KGUMD lHfiMWTIOH
1.Place backguard assembly into position on the black pedesti at rear of range. backguard bolts are attached to bottom of backguard by means of flat nuts.)
2.Bolt backguard to range with nuts. Tighten nuts snugly. Nuts are in small envelope in pack- out carton. (&cure bac~ard braces, if equipped.)
3.Insert the backguard. Disconnect plug “A” (if equipped) from range. Disconnect plug and wdl cord ‘Bn.
anifold Pipe
Do not set the range over holes in the floor or other lomtions where it may be subject to strong drafts. Any opening in the w~ behind the range and in the floor under the range should be sealed. Make sure the flow of combustion or ventilation air is not obstructed.
Left side of range ~ |
|
Location for | 20V. |
hardpipe | |
connection | O 24” |
to range |
2
Recommended gas
27