SMACE COO~G
Lighting Instructions for Electric Ignition Models JGAS02EN
The surface burners on some models me lighted by electric ignition, eliminating the need for standing pilot lights witi constandv- burning flames.
In me of a power failure, you can light the surface burners on your range with a match. Hold a hghted match to the burner, then turn the knob to the L~
msition. Use extreme mution when
Surface burners in use when an electrical power failure occurs will continue to operate normally.
The electrode of the spark igniter is exposed. men one burner is turned to LITE, W tie burners spark. Do not attempt to disassemble or clean around any burner while another burner is on.
An electric shock may result, which could cause you to knock over hot cookware.
II
Lighting Instructions for Standing mot Models
The surface burners on these ranges have standing pilots that must be tit initially. To light them:
1.Be sure surface burner control knobs are in the 0~ position. -
2.Remove the grates and lift the cooktop up (see the Cooktop section).
JGAS02PN, JLAS02PN
pilot adjustment
screw
pilot tubes
4
2pilot
\&filter
3.Locate the 2 pilot ports ad light each of them with a match.
manifold 7 | manifold |
% pipe
panel
4.If the pilots need adjusting, turn the adjusting screw located on the pilot filter.
5.Lower the cooktop. Your surface burners are now ready for use.
6.Observe lighted burners. Compare the flames to pictures in the Problem Solver. If any flame is unsatisfactory, crdl for service.
Surface Burner Controls
The knobs that turn the surface burners on and off are located on the control panel on the front of the range. The two knobs on the left control the lefi front and left rear burners. The two knobs on the right control the right front and right rear burners.
Before Lighting a Burner
●If drip pans are supplied with your range, they should be used at dl times.
●Make sure dl the grates on the range are in place before using any burner.
8