BEFOREYOU BEGIN
Read these instructions completely and carefu~y.
WORT~ | Save these instructions for the | |||
lod | electricrd inspectors use. |
| ||
~PORT~ | OBSERVE ~ | |||
CODES ~ | ORDIN~C~. |
| ||
N~ | ~ | have | these instructions |
with the appfianceafter initiation is completed.
N~ TO CONSUMER Keep tils Use and Care Guide and Ins~ation Instructions for future use.
N~. | This apptiancemust be properlygrounded. |
TOOLSYOU WILL NEED
. kge bladescrewdriver
●Channellockpfiersor smallratchetwrench (forlevehg range)
●l/4inch hex head nutdriver
ELECTRIU REQUIREMENTS
DO NOT USE ~
= ~S ~P~CE.
This apptice must be supptied with the proper voltage and frequency, and connected to an individud, properly grounded branch circuit protected by a circuit breaker or time delay fuse, as noted on the rating plate.
Wtig must conform to Natioti Electrid Codes.
Hthe electric service provided does not meet the above spectications, it is recommended that a ticensed electrician insti an approved outiet
Because the range terminals are not accessible after the range is in position, a flexibleservice conduit or cord must be used.
Step 1
CHOOSEM lNSTMMT!OHLOUTIOW
Choosea ltim based on the foU* *H:
1.The range is designed to be vented outdoors.
2.The electrid rating is 14.7~, 120/240 V,
60W.
3.Drafts caused by home heating and ~ conditioning and or open doors or windows can disrupt the ventilation air pattern. The range should not be instied near windows or doors.
4.The unit cannot be instied in a tunnel type WWopening. M currents moving through the tunnel m disrupt the ventilationair pattern.
5.The range can either be ducted through the wd or through the floor to the outside.
6.Make sure there is adequate space for proper initiation.
7.Remove protective packing materials from the range. Tape residue can be cleaned with a soft cloth and alcohol.
8.Carefu~y read d instructions before beginning initiation.
(continuednti)age)
47