GE JTP13, JTP14 Opemt~G T~ Self-Clea~G Oven, How to Set Oven for Cleaning, To Stop a Clean Cycle

OPEMT~G T~ SELF-CLEA~G OVEN

(continued)

How to Set Oven for Cleaning

Quick Reminder:

1.Press the AUTO SELF CLEAN pad.

2.Press the INCREASE or DECREASE pad until the desired Clean Time appears.

If the oven is too hot and you start to set a clean cycie, the word “OFF” will appear in the display. Allow additional time for cooling before you ~ to set the cycle.

1.Follow the directions in the Before a Clean Cycle section.

The self-clean cycle will automatically begin after “CLEAN” is displayed and the time for the clean cycle is set. The words “ON” and “LOCK” will appear in the display when the door automatically locks. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCK light goes off.

4.When the LOCK light is off, open the door.

NOTE:

	● You can find out when the clean
s;~[	cycle will be finished by pressing
n the STOP TIME pad.

nAUTO SELF

CLEAN

A@

e

v

2.After closing the door, press the

AUTO SELF CLEAN pad.

3.Press the INCREASE or DECREASE pad until the desired Clean Time is displayed.

Clean Time is normally 3 hours.

You can change the Clean Time to any time between 2 and 4 hours, depending on the amount of soil in your oven.

A

●The word “door” will be displayed, the word “LOCK” will flash and oven control will signal if you set the clean cycle and forget to close the oven door.

●A fan may automatically turn on and off to cool internal parts. This is normal, and the fan may continue to run after the oven is turned off.

To Stop a Clean Cycle

oCLEAR 1. Press the CLEAWOFF pad.

OFF

2.When the LOCK light goes off and the oven has cooled below the locking temperature, open the door.

20