GE JVM193K, JVM190K manual LIGHT B~B ~PLACEmNT, Cooktop Light, Oven Light

LIGHT B~B ~PLACEmNT

Cooktop Light

To replace the
combination	~	u\
cooktop lighti
night light, first

disconnect

power at main by- :“TJ

fuse or circuitREMOVE SCREW

Be sure bulbs to be replaced are cool before removing. Break the adhesive

seal by gently

unscrewing the bulbs. ,ep,acewith,owatt

~~ ~\

j(g<;ffl -

‘T’ d

breaker panel or pull plug.

Remove screw on right side of light compartment cover and lower cover until it stops.

incandescent bulbs (WB02X4253) available from your GE supplier. High intensity 40-watt bulbs (40Sll N/1), which are available in supermarkets and hardware stores, may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Oven Light

To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold

it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with

a 40-watt incandescent bulb

(WB02X4253), available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia

may be added to the water. Take

care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.

43