Instructions
Using the self-cleaning oven.
The oven door must be closed and all controls must be set correctly for the cycle to work properly.
Care and Cleaning Operating Instructions Safety
How to Delay the Start of Cleaning
NOTE: The surface burners must be turned off prior to the
Touch the SELF CLEAN LO/STD pad once for a
A
If a time other than 3 hours or
4 hours is needed, use the number pads and enter the desired clean time.
You can change the clean time to any time between 3 hours and 5 hours, depending on how dirty your oven is.
Touch the DELAY START pad.
Using the number pads, enter the time of day you want the clean cycle to start.
Touch the START pad.
The door locks automatically. The display will show the start time. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED light goes off.
When the LOCKED light goes off, you will be able to open the door.
Touch and hold the RANGE
Consumer Support Troubleshooting Tips
After a Clean Cycle
You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap- filled or plastic scouring pad and rinse thoroughly with a vinegar and water mixture.
These deposits are usually a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, repeat the cycle.
■You cannot set the oven for cooking until the oven is cool enough for the door to unlock.
■While the oven is
■If the racks become hard to slide, apply a small amount of cooking oil to a paper towel and wipe the edges of the oven racks with the paper towel.
NOTE: Touch and hold the RANGE
24
