Replacing the surface light
Care and Cleaning
Advantium Oven
1.To replace the surface light, first disconnect the power at the main fuse or circuit breaker panel.
2.Remove the screw from the side of the light compartment cover and lower
the cover until it stops.
3.Be sure the bulb to be replaced is cool before removing. Gently pull the bulb from the receptacle.
Replace with a 130 volt,
from your GE supplier.
Remove screw
4. Raise the light cover and replace the screw. Connect electrical power to the oven.
Removing and cleaning the filters
Replacing the oven cavity lamp
1.The metal filters trap grease released by foods on the cooktop. They also prevent flames from foods on the cooktop from damaging the inside of the oven.
2.For this reason, the filters must always be in place when the hood is used. The vent filters should be cleaned once a month, or as needed.
3.To remove, slide them to the rear using the tabs. Pull down and out.
4.To clean the vent filters, soak them and then swish around in hot water and detergent. Don’t use ammonia or ammonia products because they will darken the metal. Light brushing can be used to remove embedded dirt.
1.Disconnect power at the main fuse or circuit breaker panel.
2.Remove the top grill by removing the two screws that hold it in place.
3.Remove charcoal filter if present. Slide the filter toward the left and pull toward the front to remove.
NOTE: Charcoal filter is an optional kit, you may not have one.
4.Remove the screw holding the lamp shield in place.
5.Rinse, shake and let dry before replacing.
6.To replace, slide the filters into the frame slots on the back of each opening. Press up and to the front to lock into place.
5.Pull the lamp shield out. Pull the light bulb out and replace with a
6.Return the lamp and lamp shield to original position and replace screw and charcoal filter.
7.Replace the grill and 2 screws. Reconnect power to the oven
35
