Operator's Manual | Fourth Edition · First Printing |
|
|
|
|
Inspections
1Select a test area that is firm, level and free of obstruction.
At the Ground Controls
2Turn the key switch to ground control.
3Pull out the red Emergency Stop button to the on position.
Result: The beacon (if equipped) should flash.
4Start the engine. See Operating Instructions section.
Test Emergency Stop
5Push in the red Emergency Stop button to the off position.
Result: The engine will shut off after 2 to 3 seconds.
6Pull out the red Emergency Stop button to the on position and restart the engine.
Test the Machine Functions
7Do not hold the function enable switch to either side. Attempt to activate each boom and platform function toggle switch.
Result: All boom and platform functions should not operate.
8Hold the function enable switch to either side and activate each boom and platform function toggle switch.
Result: All boom and platform functions should operate through a full cycle. The descent alarm should sound while the boom is lowering.
Test the Tilt Sensor
9Turn the key switch to platform control. Pull out the platform red Emergency Stop
button to the on position.
10 Open the engine side turntable cover and locate the tilt sensor to the right of the hydraulic pump.
11 Press down one side of the tilt sensor.
Result: The alarm, located in the platform, should sound.
Test Auxiliary Controls
12Turn the key switch to ground control and shut the engine off.
13Pull out the red Emergency Stop button to the on position.
14 Simultaneously hold the auxiliary power switch on and activate each boom function toggle switch.
Note: To conserve battery power, test each function through a partial cycle.
Result: All boom functions should operate.
30 | Part No.114339 |
