Gold's Gym GGBE6974.1 manual

31. Route the Low Cable (72) under a 90mm Pulley	31
(58). Attach the Pulley and two Half Finger
	72
Guards (40) to the Center Base (2) with an M10 x	40
46mm Button Bolt (100) and an M10 Nylon
	58
Locknut (79).
	100
	2
	40
	79
32. Wrap the Low Cable (72) over a 90mm Pulley	32
(58). Attach the Pulley to the Top Frame (16) with
	79
an M10 x 42mm Button Bolt (96) and an M10	96
Nylon Locknut (79).

		16
		58
		72
33. Attach the Low Cable (72) to the “U”-bracket (47)	33
with an M6 Washer (86) and an M6 Nylon
Locknut (80). See the inset drawing. Do not
overtighten the Nylon Locknut; it should be
threaded onto the end of the Cable so that
only two threads are showing below the Nylon	72
Locknut.
	47	47
	86	45
	80
		72
34. Locate the Long Cable (54). Route the Cable	34
over a 90mm Pulley (58), and up through a
Swivel Arm (32) and the Left Upright (3). Attach
the Pulley inside the Swivel Arm with an M10 x	32	84
53mm Button Bolt (147), two M10 Washers (84),		75
two 6mm Spacers (75), and an M10 Nylon	75	147
		3
Locknut (79).
	84
	79
		54
	58
	17