Gold's Gym GGSY69320 manual Cable Assembly, Bly

	Cable Assembly	23
23.	IMPORTANT: Refer to the CABLE DIAGRAMS		74
			91	87
	on page 32 for help identifying the cables.
	Do not overtighten the bolts and nuts attach-		141
	ing the pulleys; the pulleys must be able to
	turn freely.	144
		61	141
	Open the parts bag labeled “CABLE ASSEM-
	BLY.”
	Locate the Dip Cable (74). Remove the M10	24
	Washer (91) and the M10 Nylon Locknut (87)		6	87
	from the indicated M10 x 207mm Bolt (61). Slide
	the Bolt through the eyelet on the Cable and a
	40mm Spacer (141). Re-attach the Washer and	101
	Locknut. Make sure the 22mm Spacer (144)
	and the other 40mm Spacer remain on the
	Bolt as shown.
			78	74
24. Wrap the Dip Cable (74) over a 90mm Pulley
	(78). Attach the Pulley to the Top Frame (6) with
	an M10 x 75mm Bolt (101) and an M10 Nylon
	Locknut. Do not fully tighten the Locknut yet.	25	78
				137
25. Wrap the Dip Cable (74) under a 90mm Pulley		137
	(78). Attach the Pulley and two 42.5mm Spacers		74
	(137) to the Dip Assist Frame (127) with an M10 x
	207mm Bolt (61), two M10 Washers (91), and an		87
	M10 Nylon Locknut (87).		91
		91
		61
		127
26. Wrap the Dip Cable (74) over a 90mm Pulley		26		87
	(78). Attach the Pulley to the Top Frame (6) with
	the M10 x 75mm Bolt (101) and an M10 Nylon	101		6
	Locknut (87) used in step 24.
			74
			78
27. Wrap the Dip Cable (74) under a 90mm Pulley		27
	(78). Attach the Pulley and a Cable Trap (68)
	between the second set of holes from the top of	74	100
	the Pulley Plates (63) with an M10 x 50mm Bolt	78
	(100) and an M10 Nylon Locknut (87). Make sure
	that the Cable Trap is turned to hold the Cable
	in place.	87	68
			63
		14