Gold's Gym GGSY69320 manual Bracket must be able to pivot easily, Is above the Leg Lever Cable

41. Wrap the Butterfly Cable (69) under a 90mm	41
Pulley (78). Attach the Pulley to the Double “U”-
bracket (62) with an M10 x 45mm Bolt (93) and
an M10 Nylon Locknut (87).
					69
				87	78
					93
					62
42. Wrap the Butterfly Cable (69) over a “V”-pulley	42		98
(55). Attach the “V”-pulley and a Long Cable Trap
				102
(102) to the Butterfly Upright (3) with an M10 x
57mm Bolt (98) and an M10 Nylon Locknut (87).				69
Make sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.			55
			87
				3
43. Lubricate an M10 x 50mm Bolt (100) with grease.	43
Attach a Pivot Bracket (70) to the Right Butterfly
Arm (26) with the Bolt and an M10 Nylon Locknut			100	103
(87). Do not overtighten the Locknut; the Pivot		Lubricate		69
Bracket must be able to pivot easily.
Attach the Butterfly Cable (69) to the Pivot			70
			71
Bracket (70) with an M8 x 20mm Shoulder Bolt
(103) and an M8 Nylon Locknut (71). Do not		26			87
overtighten the Locknut; the Cable must be
able to pivot easily.
44. Locate the Leg Lever Cable (75). Route the	44
eyelet end of the Cable through the Seat Leg (9)
and attach it to the tab on the Leg Lever (10) with			10
an M8 x 20mm Shoulder Bolt (103) and an M8					75
			71	9
Nylon Locknut (71). Do not overtighten the
Locknut; the Cable must be able to pivot easi-
ly.
					103
45. Attach a 90mm Pulley (78) inside of the Seat Leg	45			9
(9) with an M10 x 65mm Bolt (18), two M10
		87
Washers (91), two 12.5mm Spacers (89), and an			89
M10 Nylon Locknut (87). Make sure the Pulley		91		78
is above the Leg Lever Cable (75).					75
					89	18
					91

18