Gold's Gym GGSY69320 manual Pletely tighten the Locknut it should be tight, Drawing

56. Attach the Squat Low Cable (72) to the other	56
Small “U”-bracket (106) with an M8 Washer (90)
and an M8 Nylon Locknut (71). Do not com-			72
pletely tighten the Locknut; it should be tight-			108
ened so that only two threads of the Cable
show past the Locknut, as shown in the inset			106
drawing.
Attach the Small “U”-bracket (106) to the Short	72		90
			71
Weight Tube (122) with an M8 x 45mm Bolt (108)			122
and an M8 Nylon Locknut (71). Do not overtight-
en the Locknut; the Weight Tube must be able	71
to pivot in the “U”-bracket.
57. Locate the Lat Cable (88). Route the Cable up	57	88
through the Butterfly Top Frame (7) and over a
90mm Pulley (78). Attach the Pulley inside the		91	78
Butterfly Top Frame with an M10 x 65mm Bolt			7
		87
(18), two M10 Washers (91), two 12.5mm
Spacers (89), and an M10 Nylon Locknut (87).		89	91
			89
			18
58. Wrap the Lat Cable (88) over a 90mm Pulley	58
(78). Attach the Pulley and a Cable Trap (68) to
			78
the Top Frame (6) with an M10 x 50mm Bolt
		87	88
(100) and an M10 Nylon Locknut (87). Make sure
the Cable Trap is oriented to hold the Cable in			68
the groove of the Pulley.
			100
59. Wrap the Lat Cable (88) under a 90mm Pulley	59		88
(78). Attach the Pulley to the Long Base (120)
		93
with an M10 x 45mm Bolt (93) and an M10 Nylon
Locknut (87).		78
			87
			120
60. Remove the indicated 90mm Pulley (78) from the	60
Short Base (2). Route the Lat Cable (88) under
			118
the 25mm Spacer (118) and under the Pulley.		78
Reattach the Pulley to the Base with the M10 x		88
75mm Bolt (101) and an M10 Nylon Locknut (87).		87
		2	101
	21