Graco 24B596, 24B591 Power UP Setup, Power Up can be programmed one of four ways

Setup

4.Use the RIGHT arrow to move the cursor to the next field. Repeat step 3.

NOTE: The maximum number of Counts you can setup in this field is 9999.

5.Use the Arrow keys to move the cursor over the TIME field.

6.Press ENTER.

NOTE: Time is displayed in HH:MM:SS.

7.Use the UP/DOWN arrows to move up and down through the numbers 0-9 until the first number in the PUMP OFF time is displayed in the field.

8.Use the RIGHT arrow to move the cursor to the next field. Repeat step 7.

9.Repeat steps 7 and 8 until the desired time is dis- played.

10.Press ENTER.

11.Use the Arrow keys to move the cursor over the TIMEOUT pull-down menu.

FIG. 33

12.Press ENTER.

13.When time expires:

•Select FAULT if an alarm should occur.

•Select RUN if unit should enter PUMP ON.

14.Press ENTER.

15.Press RESET. The Main Screen, page 18 displays.

NOTE: If Count or Both is selected, the Count Icon dis- plays in the upper right corner of the screen.

POWER UP Setup

FIG. 34

1.Use the UP/DOWN Arrow keys to move the cursor over POWER UP.

2.Press ENTER to display the POWER UP setup screen.

Power Up can be programmed one of four ways:

First: At Power Up, the normal lube cycle that was in process when power was removed, is resumed.

FIG. 35

1.Use the Arrow keys to move the cursor over the POWER UP pull-down menu.

2.From the pull-down menu, select OFF.

3.Press ENTER.

4.Use the Arrow keys to move the cursor over the DELAY pull-down menu.

5.From the pull-down menu, select OFF.

6.Press RESET. The Main Screen, page 18 displays.

22 313855H