Display Setup, Quick Cycle Setup, Display Backlight | Graco 24B596

Setup

DISPLAY Setup

FIG. 46

1.Use the UP/DOWN Arrow keys to move the cursor over DISPLAY.

2.Press ENTER to display the DISPLAY setup screen.

Display Backlight

The display backlight can be set to turn off after a pro- grammed amount of time. If the backlight is OFF it will turn back on when any front panel key is pressed.

FIG. 47

1.Use the Arrow keys to move the cursor over the TIMER pull-down menu.

2.From the pull-down menu, select ON.

3.Press ENTER.

4.Use the Arrow keys to move the cursor over the TIME ON field.

FIG. 48

NOTE: Time is displayed in HH:MM.

5.Use the UP/DOWN arrows to move up and down through the numbers 0-9 until the first number in the TIME ON is displayed in the field.

6.Use the RIGHT arrow to move the cursor to the next field. Repeat step 5.

7.Repeat steps 5 and 6 until the desired time displays.

8.Press RESET. The Main Screen, page 18 displays.

QUICK CYCLE Setup

FIG. 49

1.Use the UP/DOWN Arrow keys to move the cursor over QUICK CYCLE.

2.Press ENTER to display the QUICK CYCLE setup screen.

26

313855H

Image 26

Graco 24B596, 24B591 important safety instructions Display Setup, Quick Cycle Setup, Display Backlight

Contents

Important Safety Instructions GLC Lubrication Controller Electric Shock Hazard Keypad, Display, and Icons Run Mode FunctionsComponent Identification Direction Arrows Icons Installation Typical Installation Installing the Lubrication Controller Grounding Sensor Wiring Configurations System Configuration and WiringSystem Configurations Modes of Operation Optional I/O Wiring Diagrams System Configuration Divider Valve System Dual Line System Injector System Source Switch 2 or 3 Wire Type System WiringInput Sensor Wiring Pump on = Time Pump OFF = Time 30VDC Dry Contact, shown. For other configuration, see or FIG Pump on = Cycle or Pressure Pump OFF = Time Pump on = Cycle or Pressure Pump OFF = Machine Count System Wiring Options 100/240VAC System Wiring Options Alarm Out30VDC See Electric Connection Warning, SetupSystem Setup PIN Mode Enabled Timer Setup System SetupPump on Setup Main Screen Pressure Setup Cycle END Setup To Set the Pump OFF Option Pump OFF SetupCycle Mode Selection If Both is selected If Time is selectedIf Count is selected Power UP Setup Power Up can be programmed one of four ways Third At Power Up, immediately go to Pump on normal on time Pulsed Setup Pulsed Pump Screen PIN Setup To enable PIN Code Entry Display Backlight Display SetupQuick Cycle Setup LOW Level Filtering Setup Quick Cycle Screen Setup Low Level Filtering Screen Setup Run Mode Screen Identification Pump On Ended with Time Prelube Power UpPump On Ended with Pressure Pump Off Ended with Machine Counts Pump On Ended with Cycle Switch ActivationPump Off Ended with Time Alarms Screen Pump Off Ended with Machine Counts Max Time Entered Description Problem Solution TroubleshootingProgram Settings Modes of Operation Technical Data IP69K Dimensions Mounting Hole Layout Graco Standard Warranty Graco Information