Graco 16H245, 262612, 16H241, 16H243, 16H242, 16F887 16H240, 16H829 Grounding Wire Repair

Warnings

Warnings

The following warnings are for the setup, use, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these sym- bols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.

WARNING

FIRE AND EXPLOSION HAZARD (GROUNDING)

Some oil-based and flammable materials generate static electricity when sprayed. Static electricity creates an explosion and fire risk. Your sprayer has a grounding cord that will conduct the static electricity to a grounded electrical outlet. The sprayer and all objects in spray area shall be properly grounded to protect against static discharge, sparks or shocks.

•Connect the grounding cord when spraying flammable or static producing oil-based materials.

•If there is static sparking or if you feel a shock, stop spraying immediately and connect the sprayer to a properly grounded electrical outlet with the ground wire provided.

GROUNDING INSTRUCTIONS

Move the sprayer away from the spray area to a non-hazardous location. Plug the ground wire into the sprayer.

Unwind the ground wire from the spool and plug it into a properly grounded electrical outlet.

If the ground wire is not long enough to reach a grounded electrical outlet, a

3-wire grounded extension cord may be used to reach a grounded outlet.

Grounding Wire Repair

If the grounding wire breaks at the spool end, perform the following steps:

1.Unwind wire from grounding spool and use a flat screwdriver to pry apart the grounding spool.

If the grounding wire breaks at the grounding plug, perform the following steps:

1.Pull rubber boot off of wire at grounding plug and slide boot over grounding wire.

ti17082a

2.Loosen screw on terminal and remove broken wire. Strip insulation from grounding wire, insert into ter- minal and tighten screw.

ti17081a

2.Loosen screw and remove broken wire. Insert stripped grounding wire and tighten screw.

3.Replace rubber boot onto grounding plug.

ti17080a

3. Snap the grounding spool back together.

3A1698F 3