Charging the Battery

Charging the Battery

Replace and charge battery only in a well-ventilated area and away from flammable or combustible materials, including paints and solvents.

Batteries are initially 50% charged to provide optimum bat- tery life and require charging before first use. It takes approximately 25 minutes to charge a dead battery to 80%, at which point it can be used. It will take approximately 40 minutes to fully charge a dead battery.

1.Place charger in a dry, well-ventilated area and away from flammable or combustible materials, including paints and solvents.

2.Plug charger into an electrical outlet and slide battery into charger as shown (light will turn on in 5 seconds).

3.When battery becomes fully charged, immediately unplug the charger from the power supply and remove the battery from the charger.

NOTE: The amount sprayed with each battery varies depending on material, tip size, motor speed and pressure setting. Typical results are 1 to 6 cups of material sprayed per battery. Generally you will get longer battery life at higher pressure settings and at low motor speed.

ti16706a

Charger Status Indicator Lights

 

Label

Appearance

Description

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Solid green light

Indicates a full charge. Battery can be used.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Flashing green light

Battery is charging, indicates 80% charge.

 

 

 

 

 

 

 

 

Battery can be used.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Flashing red light

Battery is charging, indicates less than 80% charge.

 

 

 

 

 

 

 

 

Do NOT use battery.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Solid red light

Battery is too hot or too cold to charge. Remove battery and allow to cool or

 

 

 

 

 

 

 

 

warm up before charging.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Sprayer Status Indicator

Light*

 

Appearance

Description

 

ti16707a

No light

Normal operation.

 

Solid red

Battery is low on power and needs to be charged, or battery is too cold

 

 

 

 

 

and must warm up before spraying.

 

 

Flashing red

Battery temperature is too high, or tip is clogged.

 

 

 

See Troubleshooting, page 26.

*NOTE: The sprayer status indicator light is visible for 10 seconds after the trigger is released.

8

3A1698F

Page 8
Image 8
Graco 16H241, 262612, 16H243, 16H245, 16H242 Charging the Battery, Charger Status Indicator Lights, Sprayer Status Indicator