3.Set temperatures
A
B
°F
°C
Temperature Controls and Indicators, see page 13
This equipment is used with heated fluid, which can cause equipment surfaces to become very hot. To avoid severe burns:
•Do not touch hot fluid or equipment.
•Allow equipment to cool completely before touch- ing it.
Wear gloves if fluid temperature exceeds 110°F (43°C).
a. Turn main power ON | . |
b. Press °F or °C | to change temperature |
scale. |
|
c. Press 
.
d. To set A heat zone target temperature,
press 
or 
until display shows
Startup
desired temperature. Repeat for B and
zones.
NOTE:
For 
zone only, if FTS is disconnected at startup, display will show hose current (0A). See step j, page 26.
e. Press 
to display actual temperatures.
Do not turn on hose heat without fluid in hoses.
f.Turn on 
heat zone by pressing 
. Preheat hose
Thermal expansion can cause overpressurization, resulting in equipment rupture and serious injury, including fluid injection. Do not pressurize system when preheating hose.
g. Turn on A and B heat zones by press-
ing 
for each zone.
h.Hold 
to view electrical currents for each zone.
i.Hold 
to view heater control circuit board temperature.
313539F | 25 |
