
Startup
2.Load fluid with feed pumps
NOTE:
The Reactor is tested with oil at the factory. Flush out the oil with a compatible solvent before spraying. See page 38.
a.Check that all Setup steps are complete.
b.Turn on component B agitator, if used.
c.Turn both PRESSURE RELIEF/SPRAY valves
(SA, SB) to SPRAY | . |
SA | SB |
ti9877a
d.Start feed pumps.
e.Open fluid inlet valves (FV). Check for leaks.
FV
ti10972a
Do not mix components A and B during startup. Always provide two grounded waste containers to keep component A and component B fluids separate.
f.Use feed pumps to load system. Hold gun fluid manifold over two grounded waste containers.
Open fluid valves A and B until clean,
ti2484a
24 | 313539F |