Temperature Controls and Indicators | Graco 313539F specs

Temperature Controls and Indicators

Temperature Controls and Indicators

Heater Power Indicators

Heater Displays

Zone A Arrow Keys

Zone B Arrow Keys

Hose Zone Arrow Keys

A

B

Heater A On/Off Key

Heater B On/Off Key

Hose Heater On/Off Key

°F

Actual Temperature Key

Temperature Scale Keys

°C

Target Temperature Key

FIG. 5. Temperature Controls and Indicators

Main Power Switch

Located on right side of unit, page 11. Turns Reactor

power ON	and OFF	. Does not turn
heater zones or pumps on.

Red Stop Button

Located between temperature control panel and motor

control panel, page 11. Press to shut off motor

and heater zones only. Use main power switch to shut off all power to unit.

Actual Temperature Key/LED

Press to display actual temperature.

Press and hold to display electrical current.

Target Temperature Key/LED

Press to display target temperature.

Press and hold to display heater control circuit board temperature.

313539F

13

Image 13

Graco 313539F Temperature Controls and Indicators, Main Power Switch, Red Stop Button, Actual Temperature Key/LED

Contents

Operation Important Safety Instructions Models Contents Related Manuals Supplied Manuals Electric Shock Hazard Fire and Explosion Hazard Material Self-ignition Isocyanate ConditionsKeep Components a and B Separate Moisture Sensitivity of Isocyanates Changing Materials Key for FIG Typical Installation, with circulationSide Supply Detail Typical Installation, without circulation Reactor H-VR Component Identification Inside cabinet Detail of Reactor Fluid Manifold Shroud removed for clarity Detail of Pump Assembly guard removed for clarity Pump Assembly Main Power Switch Temperature Controls and IndicatorsActual Temperature Key/LED Target Temperature Key/LED Temperature Arrow Keys Temperature Scale Keys/LEDs Circuit BreakersTemperature Displays Heater Zone On/Off Keys/LEDs Motor ON/OFF Key/LED Motor Controls and IndicatorsPark Key/LED Pressure Key/LED Cycle Count Key/LED Spray AdjustmentsHydraulic Pressure Control Knob Motor Control Arrow Keys Locate Reactor SetupGeneral equipment guidelines Electrical requirements See table Phase Amps Watts 256886 230V 26,600 256887 400VElectrical Requirements kW/Full Load Amps Voltage System Connect feed pumps Install Fluid Temperature Sensor FTSConnect pressure relief lines Close gun fluid manifold valves a and B Connect heated hoseConnect whip hose to gun fluid manifold Pressure check hose Check hydraulic fluid level Ground system Startup Alaf Load fluid with feed pumps Set temperatures Temperature Controls and Indicators, see Set pressure Manual current control mode only Available Pressure Imbalance Settings Change pressure imbalance setting optional Spray Spraying Open gun fluid manifold valves a and B Shutdown Standby Pressure Relief Procedure Circulation Through Reactor Fluid CirculationPressure RELIEF/CIRCULATION CKR Circulation Through Gun Manifold Temperature Control Diagnostic Codes Diagnostic CodesCode Code Name Alarm Zone Code Code Name Alarm or Motor Control Diagnostic Codes Frequency of Oil Changes Ambient Recommended Temperature Maintenance Fluid Inlet Strainer Fluid Inlet Strainer Screen RELIEF/CIRCULATION Flushing Dimensions Category Data Technical Data Pressure in psi MPa, bar Performance ChartsFlow Rate in lb/min kg/min Flow Rate in gal/min liter/min Flow Rate in gpm lpm Delta T in degrees F degrees C 313539F Graco Information Graco Standard Warranty