Temperature Scale Keys/LEDs Circuit Breakers | Graco 313539F

Temperature Controls and Indicators

Temperature Scale Keys/LEDs	Circuit Breakers
Press °F or °C to change temperature scale.

Heater Zone On/Off Keys/LEDs

Press to turn heater zones on and off. Also clears heater zone diagnostic codes, see page 34.

NOTE:

LEDs flash when heater zones are on. The duration of each flash shows the extent that the heater is turned on.

Temperature Arrow Keys

Press , then press or to adjust tem- perature settings in 1 degree increments.

Temperature Displays

Show actual temperature or target temperature of heater zones, depending on selected mode. Defaults to actual at startup. Range is 32-190°F (0-88°C) for A and B, 32-180°F (0-82°C) for hose.

Located inside Reactor cabinet.

Ref.	Size	Component

CB1	50 A	Hose/Transformer Secondary

CB2	40 A	Transformer Primary

CB3	50 A	Heater A

CB4	50 A	Heater B

CB5	20 A	Motor/Pumps

CB1

CB2
CB3
CB4	CB5	ti9884a
		ti9884a

For wiring and cabling, see repair manual 313540.

14

313539F

Image 14

Graco 313539F Temperature Scale Keys/LEDs Circuit Breakers, Heater Zone On/Off Keys/LEDs, Temperature Arrow Keys

Contents

Important Safety Instructions Operation Contents Models Supplied Manuals Related Manuals Electric Shock Hazard Fire and Explosion Hazard Keep Components a and B Separate Isocyanate ConditionsMaterial Self-ignition Moisture Sensitivity of Isocyanates Changing Materials Side Supply Detail Typical Installation, with circulationKey for FIG Typical Installation, without circulation Component Identification Reactor H-VR Detail of Reactor Fluid Manifold Shroud removed for clarity Inside cabinet Pump Assembly Detail of Pump Assembly guard removed for clarity Actual Temperature Key/LED Temperature Controls and IndicatorsMain Power Switch Target Temperature Key/LED Temperature Displays Temperature Scale Keys/LEDs Circuit BreakersTemperature Arrow Keys Heater Zone On/Off Keys/LEDs Park Key/LED Motor Controls and IndicatorsMotor ON/OFF Key/LED Pressure Key/LED Hydraulic Pressure Control Knob Spray AdjustmentsCycle Count Key/LED Motor Control Arrow Keys General equipment guidelines SetupLocate Reactor Electrical Requirements kW/Full Load Amps Voltage Phase Amps Watts 256886 230V 26,600 256887 400VElectrical requirements See table System Connect pressure relief lines Install Fluid Temperature Sensor FTSConnect feed pumps Connect whip hose to gun fluid manifold Connect heated hoseClose gun fluid manifold valves a and B Pressure check hose Ground system Check hydraulic fluid level Startup Alaf Load fluid with feed pumps Set temperatures Temperature Controls and Indicators, see Manual current control mode only Set pressure Change pressure imbalance setting optional Available Pressure Imbalance Settings Spraying Spray Open gun fluid manifold valves a and B Standby Shutdown Pressure Relief Procedure Pressure RELIEF/CIRCULATION Fluid CirculationCirculation Through Reactor Circulation Through Gun Manifold CKR Code Code Name Alarm Zone Diagnostic CodesTemperature Control Diagnostic Codes Motor Control Diagnostic Codes Code Code Name Alarm or Maintenance Frequency of Oil Changes Ambient Recommended Temperature Fluid Inlet Strainer Screen Fluid Inlet Strainer Flushing RELIEF/CIRCULATION Dimensions Technical Data Category Data Flow Rate in lb/min kg/min Performance ChartsPressure in psi MPa, bar Flow Rate in gal/min liter/min Delta T in degrees F degrees C Flow Rate in gpm lpm 313539F Graco Standard Warranty Graco Information