Motor Controls and Indicators, Park Key/LED | Graco H50, H40, H25

Motor Controls and Indicators

Motor Controls and Indicators

NOTICE

To prevent damage to the softkey buttons, do not press the buttons with sharp objects such as pens, plastic cards, or fingernails.

Arrow Keys

Motor ON/OFF Key

Pressure/Cycle Display

ON / OFF

PARK Key

Pressure Key

Cycle Count Key

PARK

PSI/BAR Keys

PSI

BAR

FIG. 5. Motor Controls and Indicators

Motor ON/OFF Key/LED

PSI/BAR Keys/LEDs

Press to turn motor ON and OFF. Also

clears some motor control diagnostic codes, see page 43.

PARK Key/LED

Press at end of day to cycle component

A pump to home position, submerging dis- placement rod. Trigger gun until pump stops. Once parked, motor will automatically shut off.

Press PSI or BAR to change pressure scale.

Pressure Key/LED

Press to display fluid pressure.

If pressures are imbalanced, display shows higher of two pressures.

312062W

21

Image 21

Graco H50, H40, H25 Motor Controls and Indicators, Motor ON/OFF Key/LED PSI/BAR Keys/LEDs, Park Key/LED, Pressure Key/LED

Contents

Operation Important Safety Instructions Contents Systems GCP2R2 Series Models Approvals XP2 Series Supplied Manuals Reactor Electrical DiagramsReactor Hydraulic Proportioner Part Description Part Description Related Manuals Electric Shock Hazard Skin Injection Hazard Pressurized Aluminum Parts Hazard Isocyanate Conditions Important Two-Component Material InformationMaterial Self-ignition Keep Components a and B Separate Changing Materials Foam Resins with 245 fa Blowing Agents Key for FIG Typical Installation, with circulationSide Supply Detail Side Supply Detail M Typical Installation, without circulation Typical Installation, without circulation Component Identification Detail of Serial No Plate inside cabinet Detail of Reactor Fluid Manifold shroud removed for clarity Temperature Controls and Indicators Main Power SwitchRed Stop Button Target Temperature Key/LED Actual Temperature Key/LEDTemperature Scale Keys/LEDs Temperature Arrow Keys Size Component Circuit Breakers Motor ON/OFF Key/LED PSI/BAR Keys/LEDs Motor Controls and IndicatorsPark Key/LED Pressure Key/LED Cycle Count Key/LED Spray AdjustmentsHydraulic Pressure Control Knob Motor Control Arrow Keys Setup Locate ReactorGeneral equipment guidelines Electrical Requirements KW/Full Load Amps Phase Amps WattsElectrical Requirements Full Load Voltage Peak System Part Cord Specification Power Cord RequirementsConnect electrical cord Part Model AWG mm Connect feed pumps Connect pressure relief lines Install Fluid Temperature Sensor FTS Close gun fluid manifold valves a and B Connect heated hoseConnect whip hose to gun fluid mani- fold Pressure check hose Lubrication system setup Ground systemCheck hydraulic fluid level Check generator fuel level Startup Set temperatures Manual current control mode only Set pressure Change pressure imbalance setting optional PSI BAR Available Pressure Imbalance Settings Spraying Open gun fluid manifold valves a and B Standby Shutdown Pressure Relief Procedure Lation Fluid Circulation Circulation Through Gun Manifold Code Code Name Alarm Zone Diagnostic Codes Code Code Name Alarm or Motor Control Diagnostic Codes Frequency of Oil Changes Ambient Recommended Temperature Maintenance Fluid Inlet Strainer Fluid Inlet Strainer Screen Pump Lubrication System Pump Lubrication System Flushing Dimensions Dimension In. mmTop View Category Data Technical Data Performance Charts Foam Performance ChartCoatings Performance Chart Flow Rate in gpm lpm 110 Graco Information Graco Standard Warranty