Standby | Graco H40, H50, H25 specification

Standby

Standby

If you stop spraying for a period of time, the unit will enter standby by shutting down the electric motor and hydraulic pump, to reduce equipment wear and minimize heat buildup. The ON/OFF LED and the pressure/cycle dis- play on the motor control panel will flash when in standby.

The A , B , and heat zones

will not be shut off in standby.

To restart, spray off target for 2 sec. The sys- tem will sense the pressure drop and the motor will ramp up to full speed in a few seconds.

This feature is disabled from the factory.

To activate or disable standby, adjust DIP switch #3 on the motor control board. See Reactor Repair-Parts manual 312063.

The idle time before entering standby is user-settable as follows:

1. Turn main power switch OFF

.

2. Press and hold , then turn main power

switch ON

.

3.Press or to select desired timer setting (5-20, in 5 minute increments). This sets the length of inactive time before the unit will enter standby.

4. Turn main power switch OFF

to

save changes.

312062W

37

Image 37

Graco H40, H50, H25 important safety instructions Standby

Contents

Operation Important Safety Instructions Contents Systems GCP2R2 Series Models Approvals XP2 Series Supplied Manuals Reactor Electrical DiagramsReactor Hydraulic Proportioner Part Description Part Description Related Manuals Electric Shock Hazard Skin Injection Hazard Pressurized Aluminum Parts Hazard Isocyanate Conditions Important Two-Component Material InformationMaterial Self-ignition Keep Components a and B Separate Changing Materials Foam Resins with 245 fa Blowing Agents Key for FIG Typical Installation, with circulationSide Supply Detail Side Supply Detail M Typical Installation, without circulation Typical Installation, without circulation Component Identification Detail of Serial No Plate inside cabinet Detail of Reactor Fluid Manifold shroud removed for clarity Main Power Switch Temperature Controls and IndicatorsRed Stop Button Target Temperature Key/LED Actual Temperature Key/LEDTemperature Scale Keys/LEDs Temperature Arrow Keys Size Component Circuit Breakers Motor ON/OFF Key/LED PSI/BAR Keys/LEDs Motor Controls and IndicatorsPark Key/LED Pressure Key/LED Cycle Count Key/LED Spray AdjustmentsHydraulic Pressure Control Knob Motor Control Arrow Keys Locate Reactor SetupGeneral equipment guidelines Electrical Requirements KW/Full Load Amps Phase Amps WattsElectrical Requirements Full Load Voltage Peak System Part Cord Specification Power Cord RequirementsConnect electrical cord Part Model AWG mm Connect feed pumps Connect pressure relief lines Install Fluid Temperature Sensor FTS Close gun fluid manifold valves a and B Connect heated hoseConnect whip hose to gun fluid mani- fold Pressure check hose Ground system Lubrication system setupCheck hydraulic fluid level Check generator fuel level Startup Set temperatures Manual current control mode only Set pressure Change pressure imbalance setting optional PSI BAR Available Pressure Imbalance Settings Spraying Open gun fluid manifold valves a and B Standby Shutdown Pressure Relief Procedure Lation Fluid Circulation Circulation Through Gun Manifold Code Code Name Alarm Zone Diagnostic Codes Code Code Name Alarm or Motor Control Diagnostic Codes Frequency of Oil Changes Ambient Recommended Temperature Maintenance Fluid Inlet Strainer Fluid Inlet Strainer Screen Pump Lubrication System Pump Lubrication System Flushing Dimension In. mm DimensionsTop View Category Data Technical Data Foam Performance Chart Performance ChartsCoatings Performance Chart Flow Rate in gpm lpm 110 Graco Information Graco Standard Warranty