Actual Temperature Key/LED, Target Temperature Key/LED | Graco H40

Temperature Controls and Indicators

Actual Temperature Key/LED

Press to display actual temperature.

Press and hold to display electrical cur- rent.

Target Temperature Key/LED

Press to display target temperature.

Press and hold to display heater control circuit board temperature.

Temperature Scale

Keys/LEDs

Press °F or °C to change temperature

scale.

Heater Zone On/Off

Keys/LEDs

Press to turn heater zones on and off.

Also clears heater zone diagnostic codes, see page 42.

LEDs flash when heater zones are on. The duration of each flash shows the extent that the heater is turned on.

Temperature Arrow Keys

Press , then press or to

adjust temperature settings in 1 degree incre- ments.

Temperature Displays

Show actual temperature or target tempera- ture of heater zones, depending on selected mode. Defaults to actual at startup. Range is 32-190°F (0-88°C) for A and B, 32-180°F (0-82°C) for hose.

312062W

19

Image 19

Graco H40, H50 Actual Temperature Key/LED, Target Temperature Key/LED, Temperature Scale Keys/LEDs, Temperature Arrow Keys

Contents

Operation Important Safety Instructions Contents Systems GCP2R2 Series Models Approvals XP2 Series Part Description Reactor Electrical DiagramsSupplied Manuals Reactor Hydraulic Proportioner Part Description Related Manuals Electric Shock Hazard Skin Injection Hazard Pressurized Aluminum Parts Hazard Keep Components a and B Separate Important Two-Component Material InformationIsocyanate Conditions Material Self-ignition Changing Materials Foam Resins with 245 fa Blowing Agents Side Supply Detail M Typical Installation, with circulationKey for FIG Side Supply Detail Typical Installation, without circulation Typical Installation, without circulation Component Identification Detail of Serial No Plate inside cabinet Detail of Reactor Fluid Manifold shroud removed for clarity Main Power Switch Temperature Controls and IndicatorsRed Stop Button Temperature Arrow Keys Actual Temperature Key/LEDTarget Temperature Key/LED Temperature Scale Keys/LEDs Size Component Circuit Breakers Pressure Key/LED Motor Controls and IndicatorsMotor ON/OFF Key/LED PSI/BAR Keys/LEDs Park Key/LED Motor Control Arrow Keys Spray AdjustmentsCycle Count Key/LED Hydraulic Pressure Control Knob Locate Reactor SetupGeneral equipment guidelines Full Load Voltage Peak System Part Phase Amps WattsElectrical Requirements KW/Full Load Amps Electrical Requirements Part Model AWG mm Power Cord RequirementsCord Specification Connect electrical cord Connect feed pumps Connect pressure relief lines Install Fluid Temperature Sensor FTS Pressure check hose Connect heated hoseClose gun fluid manifold valves a and B Connect whip hose to gun fluid mani- fold Ground system Lubrication system setupCheck hydraulic fluid level Check generator fuel level Startup Set temperatures Manual current control mode only Set pressure Change pressure imbalance setting optional PSI BAR Available Pressure Imbalance Settings Spraying Open gun fluid manifold valves a and B Standby Shutdown Pressure Relief Procedure Lation Fluid Circulation Circulation Through Gun Manifold Code Code Name Alarm Zone Diagnostic Codes Code Code Name Alarm or Motor Control Diagnostic Codes Frequency of Oil Changes Ambient Recommended Temperature Maintenance Fluid Inlet Strainer Fluid Inlet Strainer Screen Pump Lubrication System Pump Lubrication System Flushing Dimension In. mm DimensionsTop View Category Data Technical Data Foam Performance Chart Performance ChartsCoatings Performance Chart Flow Rate in gpm lpm 110 Graco Information Graco Standard Warranty