Fluid Circulation
10. Set PRESSURE RELIEF/SPRAY valves
(SA, SB) to SPRAY | . |
SA |
|
SB
ti9877a
Circulation Through Gun Manifold
Do not circulate fluid containing a blowing agent without consulting with your material supplier regarding fluid temperature limits.
Circulating fluid through the gun manifold allows rapid preheating of hose.
1.Install gun fluid manifold (P) on Part 246362 accessory circulation kit (CK). Con- nect high pressure circulation lines (R) to circulation manifold.
P
CKR
ti2767a
2.Route circulation lines back to respective component A or B supply drum. Use hoses rated at the maximum working pressure of this equipment. See Typical Installation, without circulation, page 15.
3. Follow Startup procedures, page 30.
4. Turn main power ON | . |
5. Set temperature targets, see page 31. Turn
on A , B , and | heat zones by |
pressing 
.
6.Press 
to display actual temperatures.
7.Before starting motor, reduce hydraulic pressure to the minimum required to circu-
late fluid until A and B tempera- tures reach targets.
-
ti7732a
8.Press motor 
to start motor and pumps. Circulate fluid at lowest possible pressure until temperatures reach targets.
312062W | 41 |
