Grizzly G0500 instruction manual Jointer to Stand, Belt, To install the V-belt

Jointer to Stand

If you will be placing the jointer on a mobile base, set the stand on the mobile base before installing the jointer unit onto the stand.

If you will be bolting the stand to the floor, posi- tion the stand in its proper location and secure it to the floor, using fasteners through the mounting flanges shown in Figure 16, before installing the jointer unit on the stand.

Figure 17. Jointer unit mounting holes.

Figure 16. Jointer stand floor mounting flanges.

The jointer unit is very heavy—get assistance when lifting it onto the stand. Serious personal injury may occur if safe moving methods are not followed.

To mount the jointer to the stand:

1.Lift the main unit onto the stand and position the cutterhead pulley over the pulley slot in the top of the stand.

2.Carefully align the mounting holes in the stand (shown in Figure 17) with the threaded holes in the base of the jointer.

3.Secure the jointer to the stand using the (3) 3⁄8"-16 x 3⁄4" hex bolts and 3⁄8" flat washers pro- vided. Be sure not to over-tighten!

-18-

V-Belt

To install the V-belt:

1.Open the stand cover to access the motor adjustment bolts.

2.Loosen the motor adjustment bolts shown in Figure 18, and slide the motor up until you can attach the V-belts to the pulleys.

Figure 18. Motor adjustment bolts (shown

underneath stand for clarity).

3.Allow the weight of the motor to rest against the V-belts.

G0500/G1018/G1018HW 8" Jointers