7.Snap fit the grommet into the opening as shown in Figure 12. Make sure there is enough slack in the wire between the switch and the grommet before snapping the grom- met into position.
Figure 12. Installing grommet.
Wiring Connection
To connect the motor cord to the motor:
1.Remove three of the four motor mounting bolts and swing the motor toward the rear stand opening, as shown in Figure 13.
Wiring Junction Box
Figure 13. Motor positioned for easy access.
2.Remove the cover from the wiring junction box.
G0500/G1018/G1018HW 8" Jointers
3.Make the motor connections in accordance with the wiring schematics that are located on the motor label or those shown below in Figure 14 or Figure 15, depending on which voltage you decide to use.
NOTICE
If you plan to rewire your machine for 110V, you must use a different switch!
