4.Line up the holes and insert the carriage bolts as shown in Figure 9.
Figure 9. Carriage bolt placement.
5.Look under the conveyor for the carriage bolts shown in Figure 10. Place the flat washers and lock nuts on the carriage bolts and tighten.
Figure 10. Conveyor washer/nut placement.
6.Re-install the blade guard in the wheel hous- ing.
Attaching the
Hydraulics
Tools Needed | Qty |
Wrench/Socket 19mm | ....................................... 1 |
Wrench/Socket 17mm | ....................................... 1 |
The hydraulic hoses and fittings are capped for protection during shipping and labeled with an "A" or a "B" for ease of assembly.
To attach the hydraulic drive to the conveyor:
1.Remove the bolt labeled "B" from elbow fit- ting in the hydraulic drive motor.
2.Remove the cap from the hose labeled "B".
3.Thread the "B" hose into the elbow fitting as shown in Figure 11 and tighten.
"B" Bolt |
"A" Bolt |
"B" Hose |
"A" Hose |
Figure 11. Connecting the hydraulics.
4.Repeat Steps 1–3 for the "A" elbow fitting and hose.
Model G0503 (Mfg. Since 12/08) |
