Mounting Resaw to

the Floor

We recommend that you bolt your new resaw to the floor. Because this is optional and floor mate- rials may vary, floor mounting hardware is not included. It may be necessary to level the floor before installing this machine.

Note—The instructions below are given for a typi- cal heavy-duty shop floor made of 6" thick con- crete. Also, anchor studs may be substituted for lag bolts, but they will stick out of the floor if you decide to move your machine at a later point.

Tools Needed

Qty

Hammer Drill

1

Punch 12"

1

Hammer drill bit 12" x 6"

1

Hammer

1

Air Compressor

1

Vacuum

1

Hardware Needed

Qty

Lag Shields 516" x 3"

6

Lag Bolts 516" x 4"

6

Flat Washer 516"

6

To mount the resaw machine to the floor:

1.Put on safety glasses and a dust mask before starting!

2.Use the mounting holes in the resaw stand feet to act as a guide for drilling into your floor, and drill approximately 312" deep into the concrete floor.

3.Using compressed air and a vacuum, remove the concrete dust from the newly drilled holes.

4.Using the hammer and punch, pound the lag shields into the concrete below the stand feet and flush with the surface of the concrete.

5.Secure the resaw to the floor with the lag bolts and washers.

-18-

Mounting the

 

Conveyor Belt

 

Tools Needed

Qty

Wrench/Socket 17mm

1

Hardware Needed

Qty

Carriage Bolt M10-1.5 x 30

6

Flat Washer 10mm

6

Lock Nut M10-1.5

6

To install the conveyor belt onto the resaw:

1.Remove the lag bolts that secure the con- veyor belt assembly to the crate pallet.

2.Remove the blade guide (shown in the upper half of Figure 8) from the wheel housing.

Figure 8. Conveyor belt placement.

The conveyor belt is very heavy. Seek assistance or use power equipment to mount the conveyor belt.

3.Lift the conveyor belt onto the resaw body as shown in the lower half of Figure 8.

Model G0503 (Mfg. Since 12/08)

Page 20
Image 20
Grizzly G0503 instruction manual Mounting Resaw to Floor, Mounting Conveyor Belt