Installing the |
|
Blade Cover |
|
Tools Needed | Qty |
Wrench/Socket 10mm | 1 |
Hardware Needed | Qty |
Carriage Bolt | 4 |
Flat Washer 6mm | 4 |
Lock Nut | 4 |
To attach the blade cover: |
|
1.Line up the holes in the blade cover with the holes in the blade housing.
2.Drop the carriage bolts into the holes indi- cated in Figure 12.
Figure 12. The blade cover.
3.Open the wheel cover to access the carriage bolts.
4.Place the washers and lock nuts on the car- riage bolts and tighten.
Attaching the
Handwheel Handle
Tools Needed | Qty |
Wrench/Socket 19mm | 1 |
Hardware Needed | Qty |
Handwheel Handle | 1 |
To attach the handwheel handle: |
|
1.Remove the nut and washer from the handwheel handle.
2.Slide the handle shaft through the hole in the head elevation handwheel.
3.Place the lock washer on the shaft and thread on the nut.
4.Hold the handle stationary and tighten the nut with the 19mm wrench.
Figure 13. Head elevation handwheel.
Model G0503 (Mfg. Since 12/08) |
