Grizzly G0503 instruction manual Connecting to Power, To connect the resaw to the power source

Connecting to

Power

Because of the high amperage draw from this machine, we recommend that you hardwire it directly to your circuit breaker and install a lock- ing power disconnect lever near the machine. See page 12 for wiring recommendations.

If you have performed all of the previous set up instructions, you are ready to connect the resaw to the power source.

Tools Needed	Qty
Phillips Head Screwdriver	1
Hardware Needed	Qty
Conduit (Not Included)	Varies
Power Wires (Not Included)	Varies

To connect the resaw to the power source:

1.Read through Section 2: Circuit Requirements on page 12 to double-check that your setup follows the safety and circuit requirements.

Note—When using a phase converter, the power from the manufactured power leg (sometimes called the wild wire) can fluxuate. Connect the manufactured power leg to the S terminal to pre- vent damage to the transformer. The wire from the S terminal can handle some fluxuation because it goes directly to the motor. The power going to the R and T terminals goes to the transformer and must be consistent to prevent damage.

2.Connect the power wires to the main termi- nal shown in Figure 23.

Figure 23. Main terminal.

3.Close and latch the electrical panel on the machine.

4.Shut off the main power at the power source circuit breaker.

5.Connect the conduit to the shut off lever box and the bottom of the electrical panel.

6.Install the power wires to the disconnect switch.

-24- Model G0503 (Mfg. Since 12/08)