Items Needed

for Set Up

ITEM

QTY

Forklift

1

Citrus-Based Degreaser or Solvent

Varies

Metal Protectant

Varies

Hammer Drill

1

Air Compressor

1

Vacuum

1

Punch 12"

1

Hammer drill bit 12" X 6"

1

Hammer

1

Lag Shields 516" x 3"

6

Lag Bolts 516" x 4"

6

Flat Washers 516"

6

Assistants

3

Dust Collector (1500 CFM min.)

1

Dust Collection Hoses 4"

3

Hose Clamps 4"

3

Protective Gloves

1 Pair

Locking Power Disconnect Lever

1

Conduit

Varies

Conduit Connectors

2

Power Cord or Wires

See page 12

-16-

Clean Up

The wheels and the blade guides of the Model G0503 are coated with a light coat of grease to protect them from corrosion during shipment. Remove the blade guard for complete access to the blade guides and clean off the protective coating with a solvent or citrus-based degreaser such as Grizzly’s G7895 Degreaser shown on page 32. Avoid chlorine-based solvents, such as acetone or brake cleaners, as they may damage painted surfaces. Always follow the manufactur- er’s instructions when using any type of cleaning product.

After the wheels and guide block assemblies have been cleaned, coat them liberally with a metal protectant and reinstall the blade guard. For metal protectants, we recommend using G96® GUN TREATMENT or BOESHIELD® T-9 shown on page 32.

Gasoline and petroleum products have low flash points and could cause an explosion or fire if used to clean machinery. DO NOT use gasoline or petroleum products to clean the machinery.

Many of the solvents commonly used to clean machinery can be toxic when inhaled or ingest- ed. Lack of ventilation while using these sol- vents could cause seri- ous personal health risks or fire. Take precautions from this hazard by only using cleaning solvents in a well ventilated area.

Model G0503 (Mfg. Since 12/08)

Page 18
Image 18
Grizzly G0503 instruction manual Items Needed, For Set Up, Clean Up, See