GTO RB923 rev installation manual Control Board Settings, DIP Switches

CONTROL BOARD SETTINGS

DIP Switches

The four DIP switches on the control board match the operator with the type of gate on which it is installed. For example, gates may pull-to-open or push-to-open. Prior to packaging, the GTO/PRO 2000 series control board was configured for single swing gates that pull-to-open (open into the prop- erty). If your gate type matches this configuration, you DO NOT need to adjust the DIP switches; Proceed to the Potentiometers section on the next page.

NOTE: To change the DIP switch settings, you must turn
the control box power switch OFF; move the switch; then
turn the power back ON. Use a small screwdriver to move	DIP switches
the switches.
PULL/PUSH: Set to PULL for swing gates that pull-to-	PULL/PUSH
open [factory setting]; PUSH for swing gates that push-to-
	SNGL/DUAL
open (see Push to Open Installation on pages 31-32).	SEQ1
	SEQ2
NOTE: The direction a gate opens is determined by standing
inside the property and facing toward the gate.
SNGL/DUAL: Set to SNGL for a single gate leaf [factory
setting]; DUAL for dual gate leaves.
SEQ1: Controls the opening order of dual gate leaves. See
Dual Gate System Installation on page 40 for more infor-
mation. (the factory setting is OFF).
SEQ2: Controls the opening order of dual gate leaves. See Dual
Gate System Installation on page 40 for more information
(the factory setting is OFF).

	4
	3
	2
ON	1

OBSTRUCT
	SENS.
MIN	MAX
LEARN

– PWR . SW .

+ BATT

18VA

C

SO

LA

R

RED

BLK

ORG BLU GRN CLS

OPN

RED BLK

ORG BLU

GRN

CLSEDG

OPNEDG

–

+

~

~

OPERATOR

SECOND

FIRST

OPERATOR

IN

POWER

					AUTOCLOSE
							60
STATUS
								120
						OFF
						INERTIA
								MAX
						MIN
						OBSTRUCT
							SENS	.
PU	LL/P		USH					MAX
						MIN
GL/DUAL
SN		SEQ1					LEARN
		SEQ2
GRN				WHT
		ORG BLU			R	B	G
						RCVR
ALARM	ACCESSORY

22