Setting the Personal Transmitter Code | GTO RB923 rev specification

Setting the Personal Transmitter Code

All GTO transmitters are set to a standard code at the factory and are ready to activate your automatic gate operator. For your safety and security, however, we strongly recommend that you replace the factory setting with your own personal code. Follow the directions below:

1. Remove the Transmitter Cover

Grasp the sides of the access cover and slide it away from the transmitter button (see illustration). When the access cover is removed, the battery and the DIP switches will be exposed. To set a new code, use a small screwdriver to move the switches.

2. Set the transmitter DIP Switches

There are nine (9) transmitter DIP switches; each of which can be placed in three different positions (+, 0, –). DO NOT set all the switches in the same position, such as all +, all 0, or all –. Once the DIP switches have been set to a personal code, replace and close the access cover.

WARNING: No other adjustments should be made inside the transmitter.

24

Image 27

GTO RB923 rev Setting the Personal Transmitter Code, Remove the Transmitter Cover, Set the transmitter DIP Switches

Contents

Series Converting Temperature Table of Contents Disconnecting the Operator Important Safety Instructions II. During Installation Before Installation III. After Installation Secondary Means of Protection Against Entrapment Entrapment Alarm UL 325 30A.1.1A No ONE should Cross the Path of the Moving Gate Consumer/End User Required Safety Precautions for Swing Gates Install Warning SignsEntrapment Protection Moving Gate Can Cause Injury Or Death GTO/PRO 2000 Series Swing Gate Operators Technical Specifications Hardware not to scale Parts Control Box and Electrical Components Single Gate Operator Parts List Preparing the Gate Pull-to-Open Single Gate gate opens into the propertyStep Installing The Post Bracket Assembly Step Enough for the operator to pivot Connecting Operator to Post Bracket Assembly1/ nut. Note when tightening Rear mount bolt, leave it loose Installing the Gate Bracket Installing the Open and Closed Position Stops Mounting the Control Box Battery Never insert the battery with the terminals to the right Gate Length Powering the System Splice wires together Solar Zones and Gate ActivityEstimated Maximum Number of Cycles Per Day Not touch each other Make sure the exposed wires do not touch each other DIP Switches Control Board Settings Potentiometers Setting the Personal Transmitter Code Set the transmitter DIP SwitchesRemove the Transmitter Cover Mounting the Receiver MemoryRun the cable through PVC conduit to protect it from damage Setting the Closed Position Limit Switch Step For Pull-to-Open InstallationsFor Push-to-Open Installations Step Connecting Additional Safety Devices Compatible Safety Devices Safety EdgesPhotoelectric Beams ORG orange used with GRN green Connecting AccessoriesWHT white used with GRN green BLU blue used with GRN green Push-to-Open Installation Step PTO-1Step PTO-2 Step PTO-6 Step PTO-3Step PTO-4 Step PTO-5 Maintenance Maintenance and Troubleshooting GuidePage Warranty and Repair Service Limited Two Year WarrantyGTO, Inc., 3121 Hartsfield Road, Tallahassee, Florida, USA Column Installation Information GTO/PRO 2200 Dual Gate System Second Unit Parts List StepD2 Installing The Second UnitGTO Automatic Gate Lock see Accessory Catalog Step D1 Step D-5 Connecting the Second Operator to the Control BoardStepD3 Step D-4 Step D-9 Setting the Control Board for Dual Gate InstallationsStep D-7 Step D-8 Step D-11 Accessories Available Through Your Dealer RB101GTO Nema Box FM317 Master Pin Lock RB975 ACCESS-ories433IH RB509 Replacement Batteries Access -ories Installation of this operator conforms to Class Installation Check list