ACCESS-ories
Column Mount Lock Receiver
(433IH)
For mounting the Automatic Gate Lock or Bulldog Pedestrian Lock in areas with limited space between the gate and post, such as brick columns or walls.
GTO Low Voltage Wire
(RB509)
The 16 gauge dual conductor, multi- stranded, direct burial low voltage wire is required to connect the control board to the solar panel or the AC transformer. This wire is also required for installation of some
accessories such as keypads, locks, or push buttons (available in 1000' rolls and specially cut lengths).
Splice Kit - Above Ground (RB707)
For providing secure and moisture resistant above ground splices for solar panels, key pads, push buttons and other accessories using GTO low voltage wire.
Splice Kit - Direct Burial (RB708)
When direct burial wire running below ground needs to be spliced the RB708 splice kit must be used.
Master® Pin Lock (RB975)
for GTO/PRO 1000/1200
Master® Pin Lock (FM320)
for GTO/PRO 2000/2200
The pin lock is a substitute for the clevis pin at either or both mounting points of the GTO/PRO 1000 operator arms and the gate bracket end of the GTO/PRO 2000. They help prevent theft of the operator arm while allowing quick release of the operator when necessary.
4" (O.D.) Post Bracket (RB464)
Recommended for mounting GTO/PRO 2000 to a 4" gate post.
4" (O.D.) Round Post Bracket
Adapters (RB469)
These adapters are necessary when mounting the 4" post bracket to a 4" (O.D.) gate post.
Two required for each gate. Use with 4"
Post Bracket (RB464).
Operator Solar Panel (FM123 ) - Improved, Amorphous Silicon (comes woth a Two Year Warranty)
This 10 watt solar panel is a battery charger for use with GTO/PRO Low Voltage Automatic Gate Operator systems. Particularly suited for remote installations, the solar panel comes with tubular steel support, mounting clips, wire connectors, and 8 ft. of low voltage wire (for longer lengths, see RB509). All GTO low voltage operators are
Operator Solar Panel (FM122 ) - Improved Amorphous Silicon (comes woth a Two Year Warranty) The 5 watt solar panel is a battery charger for use with GTO/PRO Low Voltage Automatic Gate Operator systems. Particularly suited for remote installations, the solar panel comes with tubular steel support, mounting clips, wire connectors, and 8 ft. of low voltage wire (see Low Voltage Wire for longer wire). All GTO low volatge operators are
Dual gate installations require minimum of two (2) 5 watt solar panels for adequate charging power.
43
