Installation procedure
Install indoor unit
<The wiring method of the connection of the unit>
Connect the unit
Remove the electric box cover (1), draw the wire in the rubber lining, use wire clamp A to clamp it together with other wires, and connect the wire of the relative polarity to the inner power terminal block.
After proper connection, press the wire clamp A tight.
Bind the seal cushion on the wire. (it must be bound tight to avoid
After proper connection, reinstall the electric box cover (1).
Power terminal block
Wire clamp A
Power terminal block
Grounding wire end
This part must be sealed to prevent water from entering
Rubber lining
Electric box cover (1)
Rubber lining | Instruction: Use seal cushion to bind |
| *****tight not leaving any gap. |
| Seal cushion (little size) |
| bind the wire |
(inside) | (outside) |
Attached with seal cushion Wiring on site
29