|
| Haier air conditioner | Edition: 20070116 | ||
|
|
|
|
|
|
| Mode | Corrected contents | Corrected variable | Corrected |
|
| parameter |
| |||
|
|
|
|
| |
|
| Correct the operating mode | ETBL0 | 4.67 |
|
|
|
|
|
|
|
|
| Correct forced operating mode | ETBL1 | 6 |
|
|
|
|
|
|
|
| Heat | When the air capacity is low to | ETBL2 | 4.67 |
|
|
| correct it |
| ||
|
|
|
|
| |
|
| When the air capacity is low to | ETBL3 | 4.67 |
|
|
| correct it |
| ||
|
|
|
|
| |
|
|
|
|
|
|
| Cool and | Correct the operating mode | ETBL4 |
| |
| dry mode |
|
|
|
|
| Correct the forced operating mode | ETBL5 |
| ||
2.4 Control the temperature the area
2.4.1 Deviation
Calculation the deviation of the temperature area, as following:
Heat: E= (remote control preset temperature + corrected
Cool and dry: E=room temperature - (remote control preset temperature+ corrected value)
2.4.2 Compressor OFF OFF When E is negative and E>?T:
| Heat |
| Cool | ||
|
|
|
|
|
|
?T | TCHAHL | 0.67 | TCHACL |
| 0.33 |
After ?T variation | TCHAHH | 0.67 | TCHACH |
| 1 |
?T variation condition | When the system is start to operate, E=3.0 | , | |||
The compressor will be stopped after detected continuously for 120 seconds.
After operation starts, when compressor turns off at the first time, based on the above conditions, the unit should operate according to ?T variable data. Between the time when compressor is off and restarts, the unit should operate on ?T starting data (Except dry) and operating mode is transferring. (Except the case that waiting unit is off). Compressor starts when the wrap E is larger than
2.4.3 Compressor operating
During the time when compressor is off, after waiting for 3 minutes, the deviation E is much larger
than- T +0.67 , compressor will start to operate.
2.4.4 DASH operation
When the system starts to operate or to switch the operation mode (except compressor first to off and then to on), when the compressor is on, the system will indicate the maximum frequency satisfied condition as following:
Cool | deviate to 0 |
Dry | deviate to G area |
Heat | deviate to F area |
| - 11 - |
