Hand Held Products manual Cable Pinouts, RS-232 Output, external power IT4410 and IT4710

Cable Pinouts

RS-232 Output, external power (IT4410 and IT4710)

Decoded output data format is provided at the modular connector in the Imager.Interface cables normally supplied with the Imager are terminated with a 10 pin modular plug (P1) and a 9 pin Type D connector (P3) that is compatible with all Hand Held Products’ decoders and terminals. See chart below. (The power pigtail applies to serial wedge cable, which is not shown.)

					P2		Power Pig Tail
	P1						P2 connects to
							the external
Pin 1		Pin 10					power supply.
							Inner		Outer
				P3
			9 Pin Type D Female					View B-B
			P3 connects to your terminal.
						5			1
						9			6
10 Pin Modular Plug
							View A-A
P1 connects to the Imager.

P1							Inner
							Outer
1	NC	No Connection
2	Ground		Supply Ground
3	+5VDC		Power Connection
	Ground		Supply Ground
4
5	RXD
				Receive Data -	Serial Data to Imager
6	TXD			Transmit Data - Serial Data from Image		r
7	+5VDC			Power Connection
8
	RTS			Request to Send Data
9	CTS			Clear to Send Data
10	TRIG			External Trigger1
SH				Drain Wire (Shield)

P2

0

P3

5Red

3Black

2Green

8Blue

7Brown

SH

1.The voltage requirements for external trigger signal are Logic Low <= .3 VDC and Logic Hig >= 1.8 VDC.

10 - 6