Next, scan the Character to Trigger bar code, then the 2 digit hex value for the ASCII character that trigger the delay (refer to the "Decimal to Hex to ASCII Conversion Chart" on page 2-36).Note:If you make an error while scanning the digits (before scanning Save), scan Discard on the back cover and scan the correct digits and Save again.

Delay Length

Character to Trigger Delay

To remove this delay, scan the Delay Length bar code, then set the number of steps to 00. Scan the Save bar code from the inside back cover.

Interfunction Delay

Note: This selection is valid for keyboard wedge interfaces only.

This is a delay of up to 495 milliseconds (in multiples of 5) placed between the transmission of each segment of the message string. You can program up to 99 steps (of 5 ms each). Scan the Interfunction Delay bar code below, then scan the number of steps, and the Save bar code from the inside back cover.

Note: If you make an error while scanning the digits (before scanning Save), scan Discard on the back cover and scan the correct digits and Save again.

Prefix

Scanned Data

Suffix

STX

1

HT

2 3 4 5

CR

LF

Interfunction Delays

Interfunction Delay

To remove this delay, scan the Interfunction Delay bar code, then set the number of steps to 00. Scan the Save bar code from the inside back cover.

Intermessage Delay

Note: This selection is valid for keyboard wedge interfaces only.

2 - 29

Page 49
Image 49
Hand Held Products 4410 manual Interfunction Delay, Intermessage Delay