Hand Held Products 4410 Table of Contents

i
Chapter 1 - Introduction and Installation
About the Hand-Held and Fixed Mount 2D Imager.............1-1
Unpacking the Imager...........................................................1-2
IT4410 Imager Identification................................................1-4
IT4710 Imager Identification................................................1-5
Connecting the Scanner in Keyboard Wedge Mode.............1-6
Connecting the Scanner to a Serial Port............................... 1-7
Reading Techniques..............................................................1-8
Chapter 2 - Programming
Introduction...........................................................................2-1
Reset Factory Settings.......................................................... 2-2
Status Check......................................................................... 2-2
All Symbologies................................................................... 2-2
Revision Selections...............................................................2-3
Terminal Interface................................................................ 2-4
Supported Terminals Chart...................................................2-5
Keyboard Country................................................................ 2-6
Keyboard Style..................................................................... 2-7
Keyboard Modifiers..............................................................2-8
Keyboard Function Relationships.........................................2-9
Communication Settings.....................................................2-10
Parity............................................................................ 2-10
Baud Rate..................................................................... 2-11
Word Length Data Bits................................................ 2-12
Word Length Stop Bits.................................................2-12
Hardware Flow Control................................................2-13
Software Flow Control.................................................2-13
Serial Triggering.......................................................... 2-14
Trigger Timeout..................................................................2-15
Power Saving Mode............................................................2-16
Power Hold Mode...............................................................2-17
LED Power Level............................................................... 2-17
LED Flashing......................................................................2-18
Table of Contents