Laser Engine

The Dolphin 7200 is currently available with four scanning options:

Standard range

Long range

High density scanning

No scan engine

The laser engine converts reflected light into a digital pattern that represents the bar code data. A clear window covers the laser engine to protect it from dust and dirt.

Image Engine

The Dolphin 7200 2D terminal is available with the following imaging options:

Standard image engine: scans 2 to 9 in. (5 to 23 cm)

High-Density: scans 2 to 4 in. (5 to 12 cm)

LX image engine: scans 2 to 15 in. (5 to 38 cm) on low density bar codes

Lanyard Eyelet for Optional Wrist Strap

This feature allows a strap to be attached to the Dolphin terminal so that it can be conveniently secured around the wrist or hooked on to a belt. Not available on the Dolphin 7200 2D or the Dolphin 7200 RS-232 terminals.

Battery Well

The battery well is a recessed area on the back of the Dolphin that holds the 3.6V battery pack.

Reset Switch

The Reset Switch is located inside the Dolphin terminal and is accessible through a small opening within the battery well. To reset the Dolphin, remove the label covering the opening and press the reset switch with a small blunt object such as a paper clip.

Note: Under normal circumstances, you should never need to reset your Dolphin terminal.

Infrared Communications Port

The Infrared Communications Port allows the Dolphin to communicate through the Dolphin HomeBase to a host serial device.

Battery Charging Contacts

When the Dolphin is placed in the main well of the Dolphin HomeBase, the Dolphin's battery pack is charged through these contacts.

Dolphin® 7200 User’s Guide

3 - 7

Page 25
Image 25
Hand Held Products Dolphin 7200 manual Laser Engine, Image Engine, Lanyard Eyelet for Optional Wrist Strap, Battery Well