TABS |
Figure 8.17 Install left and right side panels. Fold tabs over on left and right sides to hold panels in place.
TOP PANEL/BAFFLE |
Figure 8.18 Install top panel/baffle. If rear venting, set the damper prior to installing top panel/baffle. Holding panel at an angle, place one end on top of side panel and lift other end into place. Move left or right until centered.
TABS |
COMPLETED BRICK INSTALLATION |
Figure 8.19 Complete brick installation.
H. Positioning the Logs - Tiara I-B
While breakable, the logs do not become fragile until after the appliance is burned and they have cured. After curing, any handling must be done with care as breakage may occur easily.
PLEASE NOTE: Logs have been designed to work specifically with the burners of the Tiara
B.Exact placement will ensure proper operation of your gas appliance and reduce sooting.
NOTCH
#1
LOCATING PINS
Figure 8.20 Position rear log (#1) over the two locating pins.
#2
Figure 8.21 Put the right front log (#2) into place on the burner. Lean the log back towards the rear log until it fits into the notch in the rear log.
NOTE: In the Commonwealth of Massachusetts, the word damper shall be replaced with the words flue restrictor.
#1
#3
#2
Figure 8.22 Place the left front log (#3) into place on the burner. Log installation in complete.
August 1, 2008 | Heat & Glo · Tiara I B & Tiara II B · | Page 33 |