Hearth and Home Technologies TIARAI-CES, TIARA II-B Appliance Setup, A. Remove Shipping Materials

8 Appliance Setup

A. Remove Shipping Materials

Remove shipping materials from inside or underneath the firebox.

B. Top to Rear Vent Conversion

TOOLS REQUIRED: Power drill; #2 Phillips bit; high-temp sealant (optional).

Figure 8.3 Remove the inner collar adapter.

Figure 8.1 Remove top grille, as highlighted.

CAUTION

Sharp Edges

•Wear protective gloves and safety glasses during installation.

Screws

Screws

Figure 8.4 Locate the knock out on rear of appliance. Either remove the four screws holding the back shield in place, saving the screws, OR break the seal on the knock out and discard the knock out.

Figure 8.2 Remove vent pipe adapter and gasket by remov- ing 8 screws. Save the screws. (If gasket breaks, apply high-temp sealant to bottom of adapter before installing in Figure 8.8.)

Rear plate and gasket

Figure 8.5 Remove rear access plate and gasket. Save the screws.

Page 30 Heat & Glo · Tiara I B & Tiara II B · 7010-149M August 1, 2008