D. Shutter Adjustment
OPENCLOSE
Figure 8.11 The shutter is located on the underside of the appliance, on the right side. To adjust the shutter, loosen the wingnut. Retighten the wingnut after adjustment.
Moving the shutter bolt to the right closes the shutter. Moving the shutter bolt to the left, will open the shutter. Opening the shutter causes flames to become shorter and blue. Closing the shutter creates taller orange/yellow flames.
NOTE: Do not close so much as to cause a sooty flame. Improper adjustment can cause sooting in the firebox and/or on the outside of a house with a horizontal termination.
After adjustment, tighten nut to lock in place.
E. Leg Leveling System
Figure 8.14 Use a 5/32 in. (4mm) Allen wrench to adjust legs up and down to desired level.
F. Installing the Baffle - Tiara I-B
BAFFLE
BAFFLE RETAINERS
Figure 8.15 Position baffle on top of baffle retainers on left and right sides. Centering baffle on retainers, ensure that the dark painted bevelled edge and darker painted baffle bottom side faces toward the front viewing area of the firebox. Bend the center tabs up to prevent the baffle from sliding out.
G. Brick Installation - Tiara II-B
NOTE: The brick supplied with the Tiara
Figure 8.12 Thread Allen bolts through nuts until flush. The Allen bolts and nuts are included in the component pack inside the appliance firebox.
REAR PANEL |
Figure 8.16 Install rear panel by placing it behind the log pins flush and centered against back of firebox.
Figure 8.13 Slide assembled nuts and bolts into the slots on the legs with the nuts on the bottom.
Page 32 | Heat & Glo · Tiara I B & Tiara II B · | August 1, 2008 |
