Hearth and Home Technologies TIARA I-B Type A & B Co-Axial to Co-Linear, Existing Masonry Chimney

4. Existing Masonry Chimney

Type A & B Co-Axial to Co-Linear

Chimney Liner	Chimney Liner
Termination Cap	Termination Cap

Co-Axial to

3 in. (76mm Flex Line

30 ft. (9m) of 3 in. (76mm) Flex Liner Exhaust Section

This section of the chimney must be

Co-Linear Connector

Co-Axial to Co-Linear

Connector

sealed

Pipe Length	Pipe Length
Optional	Optional

Showing tw 30 ft.

(9m)Section of Flex Line

The chimney must be sealed from the 4 ft. (1m) section to termination using a smoke shelf or a damper*. The seal should be 6 in. (152mm) below the end of the 4 ft. (1m) Air Intake section.

4 ft. (1m) of 3 in. (76mm) Flex Liner Air Intake Section

*NOTE: In the Commonwealth of Massachusetts, the word damper shall be replaced with the words flue restrictor.

Type C - Up & Out Installation

Type D - Hearth Mount

TERMINATION

CAP

TOP ADAPTOR

FLASHING

RETRO	4 in. (102mm)
	FLEX LINER
CONNECTOR

90° ELBOW

DIRECT

Alcove Clearance to Combustibles must be maintained

Chimney Liner

Termination Cap

30 ft. (9m) of 3 in. (76mm)

Flex Liner Exhaust Section

This section of the chimney must be sealed

Chimney must be sealed from 4 ft. (1m) section to termination using a smoke shelf or a damper*. Seal should be 6 in. (152mm) below end of 4 ft. (1m) Air Intake section.

VENT PIPE

4 ft. (1m) of 3 in.

Co-Axial to Co-Linear Connector (76mm) Flex Liner

Air Intake Section

*NOTE: In the Commonwealth of Massachusettes, the word damper shall be replaced with the words flue restrictor.

Figure 5.24

August 1, 2008 Heat & Glo · Tiara I B & Tiara II B · 7010-149M Page 21