∙ Calibration Procedure, Setup | Omega Vehicle Security OM-550

∙CALIBRATION PROCEDURE

Using the following Calibration procedure we recommend that the OM-550 is recalibrated every 6 months.

Setup:

1.Perform a Manual Reset

2.Press the PROG key to enter the programming mode

3.Expect a printout similar to the following:

Figure A-2

4. Answer the prompts as follows:

PRESS OK

PRESS 000005

PRESS NO

PRESS (CURRENT DATE)

PRESS (CURRENT TIME)

PRESS NO

PRESS OK

PRESS YES

PROGRAMMING IS DONE

Figure A-3

OM-550

u46u

Image 51

Omega Vehicle Security OM-550 manual ∙ Calibration Procedure, Setup

Contents

Table of Contents Date Time ∙ The OM-550 Datalogger may be referred to as Logger Introduction Product Usage Warnings Operator Safety Information For protection of the OM-550 itself, observe the following Unpacking Features OM-550 FeaturesOM-550 features Activity LED & Horn Keypad ∙ ON-OFF ∙ RUN ∙ Stop ∙ PROG/EXIT∙ OK Channel Connectors ∙ Optional ConnectorsApplication To remove the Viewing Window Printer Window Serial Data Port Battery CoverThermal Paper DC Jack Tilt Stand Gain Adjust Power Supplies Probe SET InputsVoltage Transducer Inputs Probes Type Thermocouple Inputs Data Cache Programmed Features Statistics POWER-SAVE Mode LOW Battery OperationBattery Check Battery Installation Power Connection Connecting the DC Power Cable Connecting the AC Power Adapter Paper Installation PIN Adapter Data Port Connection ∙ Programming outline 1. Select Channel Programming Programming Keys Position Print Formatting Voltage Channels Temperature Channels Math PSEUDO-CHANNEL LOG Interval This Interval Overrun can be avoided in two waysNot Printing Operation AT Full Cache Recording Time Rejection Frequency Temperature Units To return to Normal mode Calibration Mode Tadjust R1 = 2 R2 = V-2 Voltage Input ScalingMatching Transducers to the OM-550 Matching a Voltage Transducer Matching a Current Transducer = 2.0000 VDC = R1R1 = 2 Data Scaling mX + b calculation Matching and Scaling a Voltage Transducer VDC Example Matching and Scaling a Current Transducer U38u Unit Labels Programmed Information Operation Log Interval Time Temperature Units Enter a Tadjust value, or press OK to finish programming U44u Appendix a Calibration ∙ Manual Reset Manual Reset programs the OM-550 as follows∙ Performing a Manual Reset Setup ∙ Calibration Procedure ∙ Thermocouple Adjustment Procedure ∙ Voltage Adjustment Procedure To return to normal operation ∙ Exiting CAL Mode Appendix B Specifications Voltage Measurement InputsAccuracy Conversion PrinterPaper Life Digital Interface RS-232 Connectors POWER/CURRENT RequirementsBattery Life Physical Dimensions OM-550 DOS Software Table of Contents Introduction How to Use This Manual Fonts Used in this Manual Printer CPU, RAM, Hardware ∙ Hard Drive Installation Software Installation To start the program Starting the Program Master Menu Reading Data from the OM-550 To load a LOG file Load Existing LOG Files Modify Software Configuration U6u To list data List Data on Monitor To save data as text Print Data on PrinterSave Text File To print data To edit a plot label Edit Plot Labels HOT Plot Status BAR To Magnify a portion of the Data Graph Magnify Tool Magnify MAP Magnified Area Axis Labels To select a channel to graph Channel Data To link plot lines Channels 4 & 5 After Linking Data Graph ∙ Data Plots ∙ X-Data Cursors∙ X-Cursor Data Table To activate the Help menu Help Menu List Existing LOG Files on Printer To list log filesTo quit Appendix a KEY Functions