Help Menu | Omega Vehicle Security OM-550 specification

2.8.6 HELP MENU

Another feature of the HOT PLOT is the Help Menu. This menu lists all available Keyboard functions. Refer to APPENDIX A: KEY FUNCTIONS for more details.

To activate the Help menu:

1.Press the key and the Help menu will appear.

2.When finished, press the [esc] key to close.

Help Menu

OM-550 DOS Software

u20u

Image 82

Omega Vehicle Security OM-550 manual Help Menu, To activate the Help menu

Contents

Table of Contents Date Time Introduction ∙ The OM-550 Datalogger may be referred to as Logger Operator Safety Information Product Usage Warnings For protection of the OM-550 itself, observe the following Unpacking OM-550 Features FeaturesOM-550 features Activity LED & Horn Keypad ∙ ON-OFF ∙ RUN ∙ PROG/EXIT ∙ Stop∙ OK ∙ Optional Connectors Channel ConnectorsApplication Printer Window To remove the Viewing Window DC Jack Battery CoverThermal Paper Serial Data Port Gain Adjust Tilt Stand Power Supplies Probes InputsVoltage Transducer Inputs Probe SET Thermocouple Inputs Type Programmed Features Data Cache Statistics LOW Battery Operation POWER-SAVE ModeBattery Check Power Connection Battery Installation Connecting the AC Power Adapter Connecting the DC Power Cable Paper Installation Data Port Connection PIN Adapter Programming ∙ Programming outline 1. Select Channel Programming Keys Print Formatting Position Temperature Channels Voltage Channels Math PSEUDO-CHANNEL This Interval Overrun can be avoided in two ways LOG IntervalNot Printing Operation AT Full Cache Recording Time Temperature Units Rejection Frequency Calibration Mode To return to Normal mode Tadjust Matching a Voltage Transducer Voltage Input ScalingMatching Transducers to the OM-550 R1 = 2 R2 = V-2 = 2.0000 VDC = R1 Matching a Current TransducerR1 = 2 Data Scaling mX + b calculation Matching and Scaling a Voltage Transducer VDC Matching and Scaling a Current Transducer Example U38u Unit Labels Operation Programmed Information Log Interval Time Temperature Units Enter a Tadjust value, or press OK to finish programming U44u Manual Reset programs the OM-550 as follows Appendix a Calibration ∙ Manual Reset∙ Performing a Manual Reset ∙ Calibration Procedure Setup ∙ Voltage Adjustment Procedure ∙ Thermocouple Adjustment Procedure ∙ Exiting CAL Mode To return to normal operation Voltage Measurement Inputs Appendix B SpecificationsAccuracy Digital Interface RS-232 PrinterPaper Life Conversion Physical Dimensions POWER/CURRENT RequirementsBattery Life Connectors OM-550 DOS Software Table of Contents How to Use This Manual Introduction Fonts Used in this Manual CPU, RAM, Hardware Printer Software Installation ∙ Hard Drive Installation Starting the Program To start the program Master Menu Reading Data from the OM-550 Load Existing LOG Files To load a LOG file Modify Software Configuration U6u List Data on Monitor To list data To print data Print Data on PrinterSave Text File To save data as text Edit Plot Labels To edit a plot label HOT Plot Status BAR Magnify Tool To Magnify a portion of the Data Graph Magnify MAP Magnified Area Axis Labels Channel Data To select a channel to graph To link plot lines Channels 4 & 5 After Linking Data Graph ∙ X-Data Cursors ∙ Data Plots∙ X-Cursor Data Table Help Menu To activate the Help menu To list log files List Existing LOG Files on PrinterTo quit Appendix a KEY Functions