Heat & Glo LifeStyle 2197-980 owner manual Electrical Information, A. Wiring Requirements

12 Electrical Information

A. Wiring Requirements

NOTICE: This appliance must be installed by a qualified electrician in accordance with the relevant national and local regulations.

•Wire the appliance junction box to 220-240 VAC. This is required for proper operation of the appliance.

WARNING! Risk of Shock or Explosion! DO NOT wire 220-240 VAC to the valve or to the appliance wall switch. Incorrect wiring will damage controls.

NOTICE: The main supply to the appliance must have isolation of a minimum 1/8 in. (3 mm) contact separation in both poles.

WARNING! Risk of Injury! The gas supply shall be shut off prior to disconnecting the electrical power and remov- ing batteries (if installed) before proceeding with any maintenance to the appliance.

B. IntelliFire PlusTM Ignition System Wiring

•Wire the appliance junction box to 220-240 VAC for proper operation of the appliance.

WARNING! Risk of Shock or Explosion! DO NOT wire IPI controlled appliance junction box to a switched circuit. Incorrect wiring will override IPI safety lockout.

•Refer to Figure 12.1, IPI Wiring Diagram.

•This appliance is equipped with an IntelliFire PlusTM control valve which operates on a 6 volt/1.5 AMP system.

•Plug the 6 volt transformer plug into the appliance junction box to supply power to the appliance OR install 4 C cell batteries (not included) into the battery pack before use.

•An in-line isolation switch must be installed within 1 meter of the fireplace. This is required for servicing and/ or resetting the control module in the event of a control module LOCK-OUT.

C. Optional Accessories Requirements

•This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.

Wiring for optional Hearth & Home Technologies approved accessories should be done now to avoid reconstruction. Follow instructions that come with those accessories.

•Hearth & Home Technologies recommends that Intel- liFire PlusTM wireless controls be used for their features and functionality with the IntelliFire PlusTM ignition sys- tem.

WARNING! Risk of Shock! Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING! Risk of Shock! Replace damaged wire with type 105 ºC (221 ºF) rated wire. Wire must have high tem- perature insulation.

						240V FAN
GROUND
TO CHASSIS
TO AUX300CE		IGNITOR
		FLAME
		SENSE
6V DC SUPPLY
DC REGULATOR
		CONTROL MODULE		WHITE	ORANGE
			I			AUX300CE MODULE
			S			FAN
						AUX 1 AUX 2	TO JUNCTION
							BOX 230 VAC
		8K1 WIRE
		HARNESS				TO OPTIONAL
						COMPONENTS
		RED
						OPTIONAL ON/OFF
ORANGE	GREEN					WALL SWITCH
		BLACK
(PILOT)	(MAIN)
						BATTERY PACK
		BROWN				6V DC (C X 4)
			GROUND
Figure 12.1 IPI Wiring Diagram /RC300AU
	Heat & Glo • SOHO-N-AUB • 2197-980 Rev. F • 5/12						47